Manual Tuning; Presetting Stations - Aiwa NSX-V2100 Operating Instructions Manual

MANUIAL TUNING
PRESETTING STATIONS
MONO
TUNER
BAND
SHIFT
1 Press the TUNER/BAND button repeatedly to
select the desired band, FM or AM.
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
To sele(ct a band with the remote control
Press the BAND button while pressing the SHIFT button.
2 Press the l<< DOWN or >l UP button to select
a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed.
During FM stereo reception, [{loll) is displayed.
To searchl for a station quickly (Auto Search)
Keep the 14< DOWN or >1 UP button pressed until the tuner
starts searching for a station, After tuning in to a station, the
search stol~s.
To stop the Auto Search manually, press the
144
DOWN or >1
UP button.
* The Autcl Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the ivlONO TUNER button while pressing the SHIFT button
on the remote control to extinguish AUTO in the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press these buttons again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval,
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
"PRESET1-ING STATIONS") are cleared. The preset stations
have to be set again.
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station. Use the
preset number to tune in to a preset station directly.
1
2
3
~u
Press the TUNER/BAND button to select a band,
and press the l<< DOWN or >1 UP button to
select a station.
Press the 1I SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
Frequency
I
Preset number
Repeat steps 1 and 2.
The next station will not be stored ii a total of 32 preset stations
have already been stored for all the bands.
PRESET NUMBER TUNING
Use the remote control to select the preset number directly.
1
Press the BAND button while pressing the SHIFT
button to select a band.
2 Press the numeric buttons to select a preset
number.
Example:
To select preset number 25, press the +10, +10 and 5 buttons.
To select preset number 10, press the +10 and O buttons.
Selecting a preset number on the main unit
Press the TUNER/BAND button to select a band. Then, press
the ~ PRESET button repeatedly.
Each time the button is pressed, the next highest number is
selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
the CLEAR button, and press the II SET button within 4
seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
ENGLISH
6