Fan Speed Display; Test Operation - Haier HPU-18CRA13 - annexe 1 Operation Manual

Operation

Fan speed display

Remote controller
A
TEMP
ON
OFF
HEALTH FAN
MODE HEALTH AIRFLOW
SLEEP FRESH SWING
CLOCK SET
POWER/SOFT
TIMER
LIGHT LOCK
RESET CODE

Test operation

Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room temperature
is below 16 C, do not use it in the normal operation.
O
ON/OFF MODE
Keep pressing the "ON/OFF" time for more than 5 seconds. After you hear the "Pi" sound
twice, release your fingers from the buttons: the cooling operation starts with the air flow
speed "Hi".
Unit stop (cancel the Test operation:)
press the ON/OFF button once, then you will hear "Pi" sound and the unit will operate as
what the remote controller shows.
When you connect the power supply, all the signs of function will be displayed for 5
senconds. Then the room temperature will be shown on the display board.
When the buttons on both panel and remote controller are pressed, you will hear the sound
from the unit
AUTO
When adjusting FAN speed during system operation, every time
the FAN button is pressed, the fan speed changes as follows:
Remote controller:
Control panel:
AUTO:
LO:
AIR FLOW
AUTO LO
MED:
AUTO
HI:
L
HEALTH TEMP＋ TEMP－
19
MED HI
M
H