Akai MPC1000 Operator's Manual page 80

Effect
TREMOLO
TREMOLO changes the sound level periodically to add a periodic modulation to the amplitude of sound.
Rate field
Depth field
Invert field
FLYING PAN
This effect changes the normal position of the sound periodically and creates the effect , in which it makes the
sound feel like is is rotating around your head.
Sweep rate field
Width field
Sweep curve bend field
Pan low field
REVERB
This effect adds the reverberation to the original sound, to give the spatial effect and depth to the sound.
Input filter field
Time field
HF damp field
Reverb level field
CHORUS and FLANGER
FLANGER adds modulated delay sounds to the original sound to give a ringing effect to the sound.
Both CHORUS and FLANGER add modulated delay sounds to the original sound to give a ringing effect to the
sound. The settings are the same for both effects.
Note: You can select CHORUS and FLANGER only in the FX2.
Slow sweep rate field
Slow sweep depth field
Vibrato rate field
Vibrato depth field
Feedback field
L/R sweep sync field
-72-
You can set the speed of the modulation.
You can set the depth of the modulation.
You can set the inversion of the L/R modulation. When set to OFF, both L and R will be
modulated in the same way. When set to ON, L and R will be inverted to create a more
complex effect.
You can set the speed of the sound rotation. The higher the value is, the faster the
rotation becomes.
You can set the shift range of the position (move range). If you set this value higher,
the position of the sound changes more drastically.
You can set the type of the movement of the position.
You can set how to move the position. If you select LINER, the position moves
horizontally. If you select ROTATE, the position rotates in circle.
You can set the cut off frequency of the low-pass filter that you wish to apply to the
input signal.
You can set the length of the reverb. If you set this value higher, you can enhance the
special scope of the sound.
You can set the quality of the reverb. The lower value creates harder sounds, and the
higher value creates a softer sound.
You can set the level of the reverb.
You can set the modulation speed here.
You can set the depth of the modulation here.
You can set the detailed speed of the modulation here.
You can set the detailed depth of the modulation here.
You can set the feed back level from the output to the effect input. The effect will be
boosted and create a more unique sound.
If you set it to ON, the Sweep rate will be set at the same cycle for both the Left and
Right. If you set it to OFF, the sweep rate of the right channel will be set slightly higher
than that of the left channel and you can also create a more complicated effect.