Ending The Program Through Canceling; Standby Mode; Inlet Water Filters; Maintenance And Cleaning - Beko WMB 60831 Manual

turned while the machine is in child-proof lock
mode.
Furthermore, the lights on the auxiliary function
buttons 1 and 2 blink 3 times to show how to
exit Child-proof Lock mode.
To deactivate the childproof lock:
a) Press the auxiliary function buttons 1
and 2 for 3 sec. while any program is
running. While the lights on the auxiliary
function buttons 1 and 2 are flashing
during 3-second press and hold process,
C03, C02 and C01 labels will be displayed
respectively. Then, the "COF" label will be
displayed to show that the child-proof lock
mode has been deactivated.
b) In addition to the above method, child-proof
lock can also be deactivated by turning the
program selection knob to "On/Off" position
and selecting another program when no
program is running. Child-proof lock will
not be deactivated in case of power failures
or when the machine is unplugged. To
deactivate the child-proof lock, press the 1st
and 2nd auxiliary function buttons for 3 sec.

Ending the program through canceling

When another program is selected instead
of a running program by turning the program
selection knob, the previous program is
cancelled. The " " (End/Cancel) light flashes
continuously to indicate that the program is
cancelled. If conditions to open the door are met
during cancellation (if water level is suitable, etc.),
the "Door" light will flash for about 1-2 minutes.
When the "Door" light becomes solid after 1 or
2 minutes, it means that the door can now be
opened.
"Stand-By" mode
"Stand-By" mode will allow to save energy while
your machine is not running. Unnecessary lights
and indicators will be turned off in this mode.
Thus, maximum energy saving is provided.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than a normal amount of water
C
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its original
location.

Inlet water filters

There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where they
are connected to the tap. These filters prevent
the foreign substances and dirt in the water to
enter into the machine. Filters should be cleaned
as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
10 - EN