Beko WM5101 Installation & Operating Instructions And Washing Guidance page 27

No water can
This is not a problem. The
be seen in
water level is not visible
the machine
from the outside of the
during
machine.
washing.
Water level might be
above the lower level of
the door.
Machine might be heating
up the water or it may be
The door is
at the spinning cycle.
jammed.
Due to electrical safety
mechanism, the door can
only be opened a few
minutes after the
programme has stopped.
Machine fills
with water
Inside of machine may be
when a
hot.
process is
cancelled.
Water pressure may be
low.
Supply voltage may be
low.
Input temperature of
water may be low.
Washing time
takes longer
than the time
specified in the
manual
There may be an
imbalance of laundry in
the machine.
Number of rinses and/
or amount of rinse water
might have increased.
Run either the "Pump" or "Spin" programme.
Wait until the process is over.
Wait until the process is over.
For safety reasons, water should be cycled in
and out a couple times.
The machine will wait until there is a sufficient
amount of water, which may lengthen the
washing time to avoid poor washing results due
to insufficient water.
Washing time is lengthened to avoid poor
washing results when the supply voltage is low.
Cycle time lengthens to heat up the water when
the input water is cold. Also, washing time can
be lengthened to avoid poor washing results.
The automatic spin correction system might
have been activated due to the unbalanced
distribution of the laundry in the drum.
The laundry in the drum may be clustered
(bundled laundry in a bag). Laundry should be
rearranged and re-spun.
No spinning is performed when the laundry is
not evenly distributed in the drum to prevent
any damage to the machine and to its
environment.
Water amount is increased to obtain a
better rinse and a rinse cycle is added when
necessary.
27
EN