Table of Contents
Advertisement
6
Quick instructions for daily use
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the "On/Off" button.
2. Select the programme and the
temperature.
3. If required (according to your
machine's model):
–
select any auxiliary function,
–
adjust the spin speed,
–
set the time delay,
4. Close the loading door.
5. Press Start/Pause/Cancel button.
Cancelling a programme
•
Press "Start/Pause/Cancel" button
for 3 seconds. The machine starts
to discharge the water.
•
"Start/Pause/Cancel" and "Wash"
lights will go off after discharging
process is over and the "Spin/End"
light will illuminate
•
If the programme is cancelled in
the middle of the process, "Wash"
and "Spin/End " lights will
light up. The machine can drain
all the water or can take in water
for 3 times at most to cool down
the clothes and complete draining
process. When water discharging
process is completed, "Wash" light
will go off, "Spin/End" light will light
up.
You can make a new programme
selection when
light is lit continuously.
Adding more laundry
You may add more laundry into the
machine at the beginning of washing.
the "Ready"
Machine allows adding more laundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
of the programme:
1. Press Start/Pause/Cancel button.
Wait until the door is allowed
to open. "Ready" lamp will light up
continuously when the door is
allowed to open.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press Start/Pause/Cancel button.
Programme is in rinse hold mode
After the machine fills with water in
the final rinse step, clothes can be
soaked in the machine as long as
desired.
When it reaches this position while the
machine is running, the "Start/Pause/
Cancel" light will flash.
In the machines equipped with spin
speed selection knob, you can spin by
selecting the desired spin speed and
press "Start/Pause/Cancel" button.
As for machines not equipped with a
spin speed selection knob, you can
end the programme without spinning by
pressing the "Start/Pause/Cancel"
button to drain the water. You may spin
your clothes whenever you wish to by
selecting the spin programme.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in machine.
2. Select Spin+Pump programme.
21
EN
Hide quick links:
Advertisement
Table of Contents
