In case of difficulty
System does not respond to remote commands.
•
Make sure you are calling from a touch-tone telephone. When dialing a
number, there should be audible tones. If there are clicks instead, the
telephone is not a touch-tone telephone.
•
The answering system may not detect the remote access code while the
announcement is playing. Try entering the code again when the announcement
is over.
•
There may be noise interference on the telephone line. Press the dial
buttons firmly.
•
Make sure the remote access code is entered correctly.
•
You might be calling from a telephone which sends tones too short for the
answering system to detect.
•
If there are many messages recorded, the system may take longer than usual
to respond.
Power failure recovery.
•
If the system is disconnected from its AC power, it will not operate. The
announcement and messages are retained in memory during a power failure,
but it will be necessary to reset the clock. �ee the instructions at the bottom
of the answering machine.
•
If the system announces, "Time and day not set," after announcing the time
and day, it may be necessary to reset the clock. �ee the instructions at the
bottom of the unit.
The system takes longer than usual to respond.
•
If there are too many messages recorded, the system may take longer than
usual to respond.
The message window is off.
•
Make sure the power cord is securely connected to both the answering system
and an electrical outlet not controlled by a wall switch.
Press ON/
•
OFF
General product care
To keep the answering system working and looking good, follow these guidelines:
•
Avoid putting it near heating appliances and devices which generate
electrical noise (motors, fluorescent lights, etc.)
•
DO NOT expose it to direct sunlight or moisture.
•
Avoid dropping the answering system and/or other rough treatment.
•
Clean with a soft cloth.
•
Never use a strong cleaning agent or abrasive powder because this will
damage the finish.
•
Retain the original packaging in case it is necessary to ship it at a
later date.
to turn on the system.
11