Table of Contents
Advertisement
Connecting your equipment
Connecting external antennas
To improve FM reception, connect an external FM
antenna to FM UNBAL 75 Ω.
ANTENNA
AM LOOP
FM UNBAL 75
To improve AM reception, connect a 5 m to 6 m (16 ft. to 20
ft.) length of vinyl-coated wire to the AM LOOP terminals
without disconnecting the supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
Outdoor antenna
ANTENNA
AM LOOP
FM UNBAL 75
MULTI-ZONE setup
This receiver can power up to three independent systems
in separate rooms after you have made the proper MULTI-
ZONE connections.
Different sources can be playing in three zones at the
same time or, depending on your needs, the same source
can also be used. The main and sub zones have
independent power (the main zone power can be off while
one (or both) of the sub zones is on) and the sub zones
can be controlled by the remote or front panel controls.
Note
1 For the INTERNET RADIO (SC-35 only), HOME MEDIA GALLERY (SC-37 only), XM RADIO, SIRIUS and iPod/USB inputs, it is not possible use
the same input in ZONE 2 and ZONE 3 simultaneously.
2 • COMPONENT VIDEO ZONE 2 OUT can be used to output clear images.
• The GUI screen is not displayed if only the COMPONENT VIDEO ZONE 2 OUT jack is connected.
• The video convert function does not work for ZONE 2. Connect the composite video and component video to the same types of jacks for the
inputs and outputs.
75 Ω coaxial cable
Indoor antenna
(vinyl-coated wire)
5 m to 6 m
(16 ft. to 20 ft.)
Making MULTI-ZONE connections
It is possible to make these connections if you have a
separate TV and speakers for your primary (ZONE 2) sub
zone, and a separate TV and a separate amplifier (and
speakers) for your secondary (ZONE 3) sub zone. You will
also need a separate amplifier if you are not using the
MULTI-ZONE setup using speaker terminals (ZONE 2) on
page 38 for your primary sub zone. There are two primary
sub zone setups possible with this system. Choose
whichever works best for you.
MULTI-ZONE listening options
The following table shows the signals that can be output
1
to ZONE 2 and ZONE 3
:
Sub Zone
Input functions available
DVD, TV/SAT, DVR/BDR, VIDEO, HOME MEDIA
ZONE 2
GALLERY (SC-37 only), INTERNET RADIO (SC-35
only), iPod/USB, XM RADIO, CD, CD-R/TAPE,
TUNER, ADAPTER PORT, SIRIUS
(Outputs analog audio, composite video and
component video.)
ZONE 3
Same as ZONE 2 above.
(Outputs analog audio and composite video.)
Basic MULTI-ZONE setup (ZONE 2)
•
Connect a separate amplifier to the AUDIO ZONE 2
OUT jacks and a TV monitor to the VIDEO ZONE 2 OUT
jack, both on this receiver.
You should have a pair of speakers attached to the sub
zone amplifier as shown in the following illustration.
Sub zone (ZONE 2)
VIDEO IN
AUDIO IN
R
L
2
Main zone
BD
IN
IN
HDMI
IN
1
2
ASSIGNABLE
1 4
COMPONENT VIDEO
ASSIGNABLE
(DVD)
IN
1
(DVR/BDR)
IN
2
ZONE2
ZONE3
D
OUT
OUT
(VIDEO)
IN
3
MONITOR OUT
ZONE 2 OUT
Y
P
P
B
R
ANTENNA
AM LOOP
FM UNBAL 75
CONTROL
IR
RS-232C
IN
1
IN
(OUTPUT 5 V
IN
2
150 mA MAX)
OUT
OUT
CU-RF100
03
37
En
Advertisement
Table of Contents
