To Operate On Fan Only - Frigidaire FAH106S1T - 10000 BTU Through-the-Wall Air Conditioner Use And Care Manual

Air Conditioner Features
(continued)

TO OPERATE ON FAN ONLY:

Note: Use this function only when cooling is not desired, such as for room air
circulation. You can choose any fan speed you prefer,EXCEPT AUTO FAN.
During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode.
TO USE THE
ENERGY SAVER FEATURE:
Note: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the unit cooling
system starts again.
TIMER-DELAY
START/STOP FEATURE:
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow ( ) or DOWN arrow (v) to change the delay time by .5 hour increments up to
10 hours, then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7,
etc.). The Delay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the
same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature
is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining
until the unit will start/stop. Turning the unit "ON" or "OFF" at any timer will cancel the Delay Start/Stop function. The delay
Start/Stop feature will work until the unit either starts or stops. Once this has happened then the above steps have to be
repeated again.
LIGHT ON
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
FIRST
DO THIS:
PRESS TIMER
BUTTON
PRESS TEMP/TIMER
BUTTON
V
7
YOU WILL SEE:
LIGHT ON
YOU WILL SEE
THE TIME CHOSEN:
LIGHT ON