Using The Remote Controller - Danby DAC10011E Owner's Use And Care Manual

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
1
ON/OFF MODE
3
TEMP TEMP
S
UP DOWN
ENERGY
SAVER
TIMER
FAN
CLEAN SLEEP
AIR
NOTE
1. In the Auto mode, the air conditioner can logically choose the mode of
Cooling, Fan, Heating and Dehumidifying by sensing the difference
between the actual ambient room temperature and the set temperature
on the remote controller.
2. In the Auto mode, you can not switch the fan speed. It has already been
automatically controlled.
3. If the Auto mode is not comfortable for you, the desired mode can be
selected manually.
1
ON/OFF MODE
3
TEMP TEMP
S
UP DOWN
ENERGY
4
SAVER
TIMER
FAN
CLEAN SLEEP
AIR
NOTE:
In the Fan mode, the setting temperature is not displayed in the remote
controller and you are not able to control the room temperature either. In
this case, only step 1, 3 and 4 may be performed.
1
ON/OFF MODE
3
TEMP TEMP
S
UP DOWN
ENERGY
SAVER
FAN TIMER
CLEAN SLEEP
AIR
NOTE:
In the Dehumidifying mode, you can not switch the fan speed. It has
already been automatically controlled.
11
AUTO OPERATION
Ensure the unit is plugged in and power is
available.
2
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the mode button and select
AUTO.
3) Press the TEMP UP / DOWN button to
set the desired temperature. The
temperature can be set within a range of
17°C~ 30°C in 1°C increments.
COOLING /HEATING/FAN OPERATION
Ensure the unit is plugged in and power is
2
available.
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the MODE button to cool, heat
(cooling and heating models only) or fan
mode.
3) Press the TEMP UP / DOWN button to
set the desired temperature. The
temperature can be set within a range of
17°C~ 30°C in 1°C increments.
4) Press the FAN button to select the fan
speed in three steps- Low, Med,or High.
DEHUMIDIFYING OPERATION
Ensure the unit is plugged in and power is
2
available.
1) Press the ON/OFF button to start the air
3
conditioner.
2) Press the MODE button to select auto.
3) Press the TEMP UP / DOWN button to
set the desired temperature. The
temperature can be set within a range of
17°C~ 30°C in 1°C increments.