Using The Remote Control - Danby DAC10011E Owner's Use And Care Manual

Operating Instructions
USING THE REMOTE
CONTROL
REMOTE CONTROLLER
SPECIFICATIONS
Location of the remote controller.
• Use the remote controller within a distance of 5
5m
• The air conditioner will not operate if curtains, doors or other
materials block the signals from the remote controller to the
indoor unit.
• Prevent any liquid from falling into the remote controller. Do not
expose the remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to
direct sunlight, the air conditioner may not function properly. Use
curtains to prevent the sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either
move these appliances or call the service depot.
Model
Rated Voltage
Lowest Voltage of
CPU Emitting Signal
Signal Receiving Range
Environment
9
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
CAUTION
R15A, R15B, R15C
3.0V(Button cell: CR2025)
2.0V
5m
-5°C ~ 60°C