Making Filter Coffee, Caffè Crema Or Espresso - SEVERIN CAFISSIMO KA 5115 Manual

the process is complete, only the On/Off switch is lit.
- Close the rotary control by turning it clockwise all the way and pour away the excess
water.
The start-up procedure is now complete and the unit will automatically switch to the
heat-up mode, indicated by the flashing On/Off switch.
- If desired, the appliance can now be switched off by pressing the On/Off switch.
Making filter coffee, caffè crema or espresso
Before you start
- Each capsule contains the right amount for one cup of filter coffee, caffè crema or
espresso.
- The unit is pre-set to deliver the following amounts of water:
filter coffee: 125 ml
caffè crema: 125 ml
espresso: 50 ml
- The strength of the coffee can be adjusted to your personal taste. The ex-factory pre-
setting for the quantity of coffee delivered can be adjusted for each type of coffee
individually. It is therefore your choice whether you prefer more or less water per cup
and capsule. For more information, refer to the section 'Adjusting coffee strength by
modifying the amount of water used'.
- Filter coffee and espresso taste best when drunk from a pre-heated cup. Fill the cup
temporarily with hot water while the filter coffee or espresso is being prepared.
- If the unit is already pre-heated, a capsule should not be left inserted but unused, as the
coffee aroma might suffer from the heat.
Bleeding the system after extended periods of non-use
If the appliance has not been used for more than 2-3 days, stale water and some air will have
accumulated in the system. In this case, fill the tank with fresh water and let one cup of water
run through (see section 'Bleeding the system' or 'Short instructions').
With daily use of the appliance, this process is not necessary.
Replenishing water
The water in the tank must be replenished as necessary:
- Remove the plug from the wall outlet. Take out the tank and fill it with clean, cold tap
water observing the Max-marking.
- Replace the water tank and push it down to ensure that the valve in the bottom is open.
Reconnect the plug.
Brewing coffee
- Press the On/Off switch, which starts flashing, and pre-heating starts. As soon as the
On/Off switch and the colour-coded selector buttons are permanently lit, a brief beep is
heard and the appliance is ready.
Note: during pre-heating, occasional drops of water may drip from the capsule-holder.
This is perfectly normal and is no reason for concern.
- Push the operating lever upwards to unlock the capsule-holder and bring the holder to a
slightly lower position. Pull the holder forward and out of the appliance.
- Load the capsule into the holder.
Important: the capsule must be undamaged: do not puncture it, and do not pull the lid
off.
24