Start-Up; Before Using For The First Time - SEVERIN CAFISSIMO KA 5115 Manual

- hermetically sealed for aromatic freshness
- pre-measured portions
- directly ready for use
- quick and clean preparation
- various tastes available

Start-up

Before using for the first time

Unpacking and setting up the unit
- Unpack the unit and remove all adhesive tapes. The capsule holder
is packed separately. Always place the unit on a level surface,
impervious to water and heat.
- Place the capsule-holder in its cradle and pull the operating lever all
the way down.
Preparing the unit
- Turn the rotary control clockwise as far as it will go to ensure that
the frothing nozzle is closed.
- Check that the frothing nozzle is properly and securely fitted. The
ribbed ring on the inner sleeve must be secured hand-tight by
turning it to the left.
Filling the tank with water
- Remove the water tank by lifting it straight out.
- Fill the tank up to the Max-mark with clean, cold tap water. Do not use carbonated
mineral waters or similarly unsuitable liquids.
- Replace the water tank and push it down to ensure that the valve in
the bottom is open.
- To facilitate filling or cleaning the tank, the small lid can be taken
off. To replace or remove the lid, bring it up in a vertical position
and then slide it down or pull it out of the guide pegs.
Filling the system with water
- Insert the plug into a suitable wall outlet.
The unit has a power-cord storage compartment which can be used
for any excess length of the cord. Always push the cord down at the
exit cut-out in order to grip it safely.
- Use the On/Off switch to turn the unit on. All selector buttons as
well as the 'Water tank empty' display start flashing.
- Place a suitable container underneath the frothing nozzle. Turn the
rotary control anti-clockwise all the way.
The pump will now force water into the internal circuit system. The noise generated by
the pump is initially quite distinct, but will decrease as the system fills with water.
Once the system is sufficiently filled, a little excess water will be emitted through the
nozzle into the container placed underneath, and the pump will automatically stop. Once
23