Storage Configuration - ASROCK N68-GS3 UCC - V1.0 User Manual

3.4.4 Storage Configuration

3.4.4 3.4.4 Storage Configuration Storage Configuration Storage Configuration
3.4.4 3.4.4 Storage Configuration
BIOS SETUP UTILITY
Advanced
Storage Configuration
Onboard IDE Controller [Enabled]
Onboard SATA Controller [Enabled]
SATA Operation Mode [IDE]
IDE1 Master [Hard Disk]
[Not Detected]
IDE1 Slave
SATAII_1 [Not Detected]
SATAII_2 [Not Detected]
SATAII_3 [Not Detected]
SATAII_4 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
OnBoard IDE Controller
Use this item to enable or disable the "OnBoard IDE Controller" feature.
Onboard SATA Controller
Use this item to enable or disable the "Onboard SATA Controller" feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this option
is [IDE]. If you want to operate RAID function on SATA / SATAII HDDs, please
select [RAID]. Configuration options: [IDE] and [RAID].
* If you select [RAID] mode, SATA / SATAII HDDs can not be accessed until you finish
configuring RAID functions in NVIDIA BIOS / Windows RAID Utility.
* If you install OS on SATA / SATAII HDDs, please do not change the setting of this
item after OS installation.
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will use
the "IDE1 Master" as the example in the following instruction, which can be
applied to the configurations of "IDE1 Slave" as well.
BIOS SETUP UTILITY
Advanced
IDE Master
Device :Hard Disk
Vendor :MAXTOR 6L080J4
Size :80.0 GB
LBA Mode :Supported
Block Mode :16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-6
S.M.A.R.T. :Supported
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Disabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Options
Disabled
Enabled
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
4 3 4 3 4 3 4 3 4 3