Xp 64-Bit With Raid Functions; Installing Windows Xp / Xp 64-Bit With Raid Functions - ASROCK N68-GE3 UCC Installation Manual

1.3 Installing Windows

/ XP 64-bit With RAID Functions

If you want to install Windows
your SATA / SATAII HDDs with RAID functions, please follow below procedures
according to the OS you install.
1.3.1 Installing Windows
If you want to install Windows
functions, please follow below steps.
STEP 1: Set Up BIOS.
A. Enter BIOS SETUP UTILITY
Configuration.
B. Set the "SATA Operation Mode" option to [IDE].
STEP 2: Make a SATA / SATAII driver diskette.
A. Insert the ASRock Support CD into your optical drive to boot your system.
B. During POST at the beginning of system boot-up, press <F11> key, and
then a window for boot devices selection appears. Please select CD-ROM
as the boot device.
C. When you see the message on the screen, "Generate Serial ATA driver
diskette [YN]?", press <Y>.
D. Then you will see these messages,
Please insert a blank
formatted diskette into floppy
drive A:
press any key to start
Please insert a floppy diskette into the floppy drive, and press any key.
E. The system will start to format the floppy diskette and copy SATA /
SATAII drivers into the floppy diskette.
STEP 3: Set Up BIOS.
A. Enter BIOS SETUP UTILITY
Configuration.
B. Set the "SATA Operation Mode" option to [RAID].
STEP 4: Use "RAID Installation Guide" to set RAID configuration.
Before you start to configure RAID function, you need to check the RAID installation
guide in the Support CD for proper configuration. Please refer to the BIOS RAID
installation guide part of the document in the following path in the Support CD:
.. \ RAID Installation Guide
® 7 / 7 64-bit / Vista
7 / 7 64-bit / Vista / Vista
® TM
® XP / XP 64-bit With RAID Functions
XP / XP 64-bit on your SATA / SATAII HDDs with RAID
®
Advanced screen
Advanced screen
5 5 5 5 5
TM / Vista TM 64-bit / XP
64-bit / XP / XP 64-bit on
TM
Storage
Storage