Table of Contents
Advertisement
PS2_USB_PWR1
(see p.6 item 22)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
CLRCMOS1
(see p.6 item 13)
solder points
Note: CLRCMOS1 and CLRCMOS2 allow you to clear the data in CMOS. The data in
CMOS includes system setup information such as system password, date,
time, and system setup parameters. There are 2 ways for you to clear and
reset the system parameters to the default setup. Please turn off the computer
and unplug the power cord, then you may either short the solder points on
CLRCMOS1 by using metal material, e.g., a paper clip, for 3 seconds; or you
may use a jumper cap to short the pins on CLRCMOS2 for 3 seconds. Please
remember to remove the paper clip or the jumper cap after clearing the CMOS.
2.8 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.6 item 10)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1, see p.6 item 7)
PIN1
Connect to the motherboard
1_2
+5V
Clear CMOS
Figure
FLOPPY1
Pin1
IDE1
BLUE
80-Pin ATA 100 cable
Short pin2, pin3 to enable
2_3
+5VSB (standby) for PS/2 or
+5VSB
USB wake up events.
CLRCMOS2
(see p.6 item 17)
Secondary IDE connector (Black)
(39-pin IDE2, see p.6 item 8)
IDE2
PIN1
BLACK
Connect to the IDE devices
2-pin jumper
Description
Red marking
Advertisement
Table of Contents
