Table of Contents
Advertisement
2.6 Expansion Slots (PCI and AMR Slots)
There are 2 PCI slots and 1 AMR slot on M810LMR motherboard.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AMR slot: AMR slot is used to insert ASRock MR card with v.92 Modem functionality.
Installing an expansion card
Step 1.
Before installing the expansion card, read the documentation of the
expansion card and make necessary hardware settings for the card.
Step 2.
Remove the system unit cover (if your motherboard is already installed in a
chassis).
Step 3.
Remove the bracket facing the slot that you intend to use. Keep the screw
for later use.
Step 4.
Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 5.
Fasten the card to the chassis with screws.
Step 6.
Replace the system cover.
2.7 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "SHORT". If no jumper
cap is placed on the pins, the jumper is
"OPEN". The illustration shows a 3-pin
jumper whose pin1 and pin2 are "SHORT".
Jumper
FSB_SEL1
(see p.6 item 26)
FSB_SEL1
Note: The setting of the CPU front side bus frequency of this motherboard is by
means of the adjustment of jumper-setting. Please follow the figures above
to set the CPU front side bus frequency.
Setting
2_3
FSB 100MHz
1_2
FSB_SEL1
FSB 133MHz
Advertisement
Table of Contents
