Onboard Headers And Connectors - ASROCK M3A790GXH-USB3 - V1.0 User Manual

2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors 2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
Pin1
(see p.12 No. 31)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.12 No. 12)
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1: see p.12, No. 17)
(SATAII_2: see p.12, No. 18)
(SATAII_3: see p.12, No. 20)
(SATAII_4: see p.12, No. 19)
(SATAII_5: see p.12, No. 22)
(SATAII_6: see p.12, No. 23)
SATAII_6 SATAII_5
SATAII_6 connector can be used for internal storage device or be
connected to eSATAII connector to support eSATAII device. Please
read "eSATAII Interface Introduction" on page 43 for details about
eSATAII and eSATAII installation procedures.
eSATAII Connector
(eSATAII_TOP: see p.12, No. 41)
FLOPPY1
IDE1
PIN1
These six Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII_1 SATAII_2
SATAII interface allows up to
3.0 Gb/s data transfer rate.
SATAII_3 SATAII_4
This eSATAII connector
supports SATA data cable for
external SATAII function. The
current eSATAII interface
eSATAII_TOP
allows up to 3.0 Gb/s data
transfer rate.
3 3 3 3 3 3 3 3 3 3
the red-striped side to Pin1
connect the black end
to the IDE devices