Advanced Screen - ASROCK M3A780GXH 128M - V1.0 User Manual

3 . 4 3 . 4 3 . 4

Advanced Screen

Advanced Screen Advanced Screen
3 . 4 3 . 4 Advanced Screen Advanced Screen
In this section, you may set the configurations for the following items: CPU
Configuration, Memory Configuration, Chipset Configuration, ACPI Configuration, IDE
Configuration, PCIPnP Configuration, Floppy Configuration, SuperIO Configuration,
and USB Configuration.
Main Smart Advanced
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.
CPU Configuration
Memory Configuration
Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.4.1 CPU Configuration 3.4.1 3.4.1 CPU Configuration CPU Configuration CPU Configuration
3.4.1 3.4.1 CPU Configuration
Advanced
CPU Configuration
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
L3 Cache Allocation
Advanced Clock Calibration
Processor Maximum Frequency
North Bridge Maximum Frequency
Processor Maximum Voltage
Multiplier/Voltage Change
Memory Clock
Flexibility Option
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configuration
options: [Auto], [CPU, PCIE, Sync.], [CPU, PCIE, Async.] and [Optimized].
CPU Frequency (MHz)
Use this option to adjust CPU frequency.
PCIE Frequency (MHz)
Use this option to adjust PCIE frequency.
BIOS SETUP UTILITY
H/W Monitor Boot Security
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
If AUTO, multiplier and
[Auto] voltage will be left at the
[200] rated frequency/voltage. If
Manual, multiplier and
[100]
voltage will be set based
[Auto]
on User Selection in Setup.
[Enabled]
[Auto]
[Enabled]
[Disabled]
[BSP Only]
Select Screen Select Screen
[Disabled]
Select Item Select Item
x31.5 6300 MHZ
+- +- Change Option Change Option
x31.0 6200 MHz
F1 F1 General Help General Help
1.5500 V
F9 F9 Load Defaults Load Defaults
[Auto]
F10 F10 Save and Exit Save and Exit
[Auto]
ESC ESC Exit Exit
[Disabled]
5 7 5 7 5 7 5 7 5 7
Exit