Driver Installation Guide - ASROCK K10N78 Installation Manual

1. In order to enable the eSATAII port of the I/O shield, you need to connect the
orange SATAII connector (SATAII_6 (PORT5); see p.2/3 No.11) and the
eSATAII connector (eSATAII_TOP; see p.2 No.36 or p.3 No.35) with a SATA
data cable first.
Connect the SATA data cable
to the orange SATAII
connector
(SATAII_6 (PORT5))
2. Use the eSATAII device cable to connect eSATAII device and the eSATAII port
of the I/O shield according to the eSATAII connector that you connect the
SATA data cable.
Connect one end of the eSATAII
device cable to eSATAII device
2.11 2.11

2.11 Driver Installation Guide

2.11 2.11 Driver Installation Guide Driver Installation Guide Driver Installation Guide Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
drive first. Then, the drivers compatible to your system can be auto-detected and
listed on the support CD driver page. Please follow the order from up to bottom
side to install those required drivers. Therefore, the drivers you install can work
properly.
2.12 2.12 2.12 2.12 Installing Windows 2.12 Installing Windows Installing Windows Installing Windows Installing Windows
Vista Vista Vista 64-bit Without RAID Functions 64-bit Without RAID Functions 64-bit Without RAID Functions
Vista Vista 64-bit Without RAID Functions 64-bit Without RAID Functions
TM TM TM TM TM
If you want to install Windows
Windows Vista 64-bit on your SATA / SATAII HDDs without RAID functions, please
® TM
follow below procedures according to the OS you install.
3 4 3 4 3 4
3 4 3 4
ASRock
Connect the
SATA data cable
to the eSATAII
connector
(eSATAII_TOP)
Connect the other end of the eSATAII device cable
to eSATAII port of the I/O shield
XP / XP 64-bit / Vista XP / XP 64-bit / Vista XP / XP 64-bit / Vista XP / XP 64-bit / Vista XP / XP 64-bit / Vista
®
® XP, Windows ® XP 64-bit, Windows
K10N78-1394 / K10N78
/ / / / /
TM TM TM TM TM
® Vista TM
Motherboard
or