Onboard Headers And Connectors - ASROCK H67M-ITX User Manual

2.10 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA_2 (port 4): see p.12/13, No. 5)
(SATA_3 (port 5): see p.12/13, No. 6)
Serial ATA3 Connectors
(SATA_0 (port 0): see p.12/13, No. 3)
(SATA_1 (port 1): see p.12/13, No. 4)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.12/13 No. 7)
(9-pin USB8_9)
(see p.12/13 No. 8)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.12/13 No. 9)
These two Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
These two Serial ATA3 (SATA3)
connectors support SATA data
cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This header can be used to
1 connect the remote
GND
IRTX
controller receiver.
IRRX
ATX+5VSB
30