Connectors - ASROCK GE PRO-HT R3.0 User Manual

2.8 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over
these connectors.
Connector
FDD connector
(33-pin FLOPPY1)
(see p.7/p.8 item 15)
Note: Match the red marking on the floppy ribbon cable with Pin1.
Primary IDE connector (Blue)
(39-pin IDE1, see p.7/p.8 item 7)
IDE1
PIN1
Connect this BLUE
to the motherboard
Note: To optimize compatibility and performance, please connect your hard disk
drive to the primary IDE connector (IDE1, blue) and CD-ROM to the
secondary IDE connector (IDE2, black).
USB 2.0 header
(9-pin USB45)
(see p.7/p.8 item 12)
Infrared module connector
(5-pin IR1)
(see p.7/p.8 item 18)
Internal audio connectors
(4-pin CD1, 4-pin AUX1)
(CD1: see p.7/p.8 item 26)
(AUX1: see p.7/p.8 item 27)
Figure
FLOPPY1
Pin1
end
80-Pin ATA 100/133 cable
GND
DUMMY
GND
IRTX
1
IRRX
AUX-R
GND
GND
AUX-L
AUX1
Description
Red marking
Secondary IDE connector (Black)
(39-pin IDE2, see p.7/p.8 item 8)
PIN1
Connect this
to the IDE devices
USB_PWR
ASRock I/O
P-4
P+4
default USB 2.0 ports. If those
USB 2.0 ports on the rear
panel are not sufficient, this
P+5
USB 2.0 header is available to
P-5
USB_PWR
support 2 additional USB 2.0
ports.
This connector supports an
+5V
DUMMY
optional wireless transmitting
and receiving infrared module.
GND
These connectors allow you
CD-R
GND
to receive stereo audio input
GND
CD-L
from sound sources such as
CD1
a CD-ROM, DVD/ROM, TV
tuner card, or MPEG card.
IDE2
BLACK end
TM
provides 4