Cpu Configuration - ASROCK CONROE865PE User Manual

BIOS SETUP UTILITY
Advanced H/W Monitor
Main
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration
IDE Configuration
PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.3.1 CPU Configuration 3.3.1 3.3.1 3.3.1 3.3.1 CPU Configuration CPU Configuration CPU Configuration CPU Configuration
BIOS SETUP UTILITY
Advanced
CPU Configuration
CPU Host Frequency
[Auto]
Actual Frequency (MHz) [200]
[Enabled]
Boot Failure Guard
[Auto]
Spread Spectrum
Ratio Status Unlocked (Max :17, Min : 14)
Ratio Actual Value 17
Ratio CMOS Setting [17]
Enhance Halt State [Disabled]
Max CPUID Value Limit [Disabled]
Intel (R) Virtualization tech. [Enabled]
CPU Thermal Throttling [Enabled]
No-Excute Memory Protection [Disabled]
Hyper Threading Technology [Enabled]
Intel (R) SpeedStep(tm) tech. [Auto]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
CPU Host Frequency
While entering setup, BIOS auto detects the present CPU host frequency of
this motherboard. The actual CPU host frequency will show in the following
item.
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
Spread Spectrum
This item should always be [Auto] for better system stability.
Ratio Status
This is a read-only item, which displays whether the ratio status of this
motherboard is "Locked" or "Unlocked". If it shows "Unlocked", you will find
an item Ratio CMOS Setting appears to allow you changing the ratio value
of this motherboard. If it shows "Locked", then the item Ratio CMOS Set-
ting will be hidden. If you use the ratio value to time the CPU frequency, it will
be equal to the core speed of the installed processor.
Boot Security Exit
Configure CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
Select how to set the
CPU host frequency.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
2 5 2 5 2 5
2 5 2 5