Advanced Screen; Cpu Configuration; Ide Configuration - ASROCK ALIVENF7G-FULLHD User Manual

3.3 3.3 3.3

Advanced Screen

Advanced Screen Advanced Screen
3.3 3.3 Advanced Screen Advanced Screen
In this section, you may set the configurations for the following items: CPU
Configuration, Chipset Configuration, ACPI Configuration, IDE Configuration, PCIPnP
Configuration, Floppy Configuration, SuperIO Configuration, and USB Configuration.
Main Advanced
Advanced Settings
WARNING : Setting wrong values in below sections
may cause system to malfunction.

CPU Configuration

Chipset Configuration
ACPI Configuration

IDE Configuration

PCIPnP Configuration
Floppy Configuration
SuperIO Configuration
USB Configuration
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Setting wrong values in this section may cause
the system to malfunction.
3.3.1 CPU Configuration 3.3.1 3.3.1 3.3.1 3.3.1 CPU Configuration CPU Configuration CPU Configuration CPU Configuration
Advanced
CPU Configuration
AM2 Boost
Overclock Mode
CPU Frequency (MHz)
PCIE Frequency (MHz)
CPU/LDT Spread Spectrum
PCIE Spread Spectrum
SATA Spread Spectrum
Boot Failure Guard
Cool' n' Quiet
Secure Virtual Machine
Enhanced Halt State
Processor Maximum Multiplier
Processor Maximum Voltage
Multiplier/Voltage Change
Memory Clock
Flexibility Option
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
AM2 Boost
If you set this option to [Enabled], you will enable ASRock AM2 Boost
function, which will improve the memory performance. The default value is
[Disabled]. Please refer to caution 7 on page 8 for details.
Overclock Mode
Use this to select Overclock Mode. The default value is [Auto]. Configura-
tion options: [Auto], [CPU, PCIE, Sync.] and [CPU, PCIE, Async.].
BIOS SETUP UTILITY
H/W Monitor Boot Security
Options for CPU
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
BIOS SETUP UTILITY
If AUTO, multiplier and
[Disabled] voltage will be left at the
[Auto] rated frequency/voltage. If
Manual, multiplier and
[200]
voltage will be set based
[100]
on User Selection in Setup.
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Auto]
[Enabled] Select Screen Select Screen
Select Item Select Item
[Disabled]
+- +- Change Option Change Option
x11.0 2200 MHz
F1 F1 General Help General Help
1.400 V
F9 F9 Load Defaults Load Defaults
[Auto]
F10 F10 Save and Exit Save and Exit
[Auto] ESC ESC Exit Exit
[Disabled]
4 2 4 2 4 2 4 2 4 2
Exit