Onboard Headers And Connectors - ASROCK 870 EXTREME User Manual

2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA3_1: see p.11, No. 20)
(SATA3_2_3: see p.11, No. 19)
(SATA3_4_5: see p.11, No. 18)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.11 No. 30)
(9-pin USB8_9)
(see p.11 No. 29)
(9-pin USB10_11)
(see p.11 No. 27)
These five Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Besides six default USB 2.0
USB_PWR
P-7
ports on the I/O panel, there are
P+7
GND
DUMMY
three USB 2.0 headers on this
motherboard. Each USB 2.0
1
GND
header can support two USB
P+6
P-6
2.0 ports.
USB_PWR
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
USB_PWR
P-11
P+11
GND
DUMMY
1
GND
P+10
P-10
USB_PWR
2 4 2 4 2 4 2 4 2 4