Ide Configuration - ASROCK 775V88 User Manual

3.3.4 IDE Configuration

Advanced
IDE Configuration
OnBoard IDE Controller
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
OnBoard IDE Controller
You may enable either the primary IDE channel or the secondary IDE channel.
Or you may enable both the primary and the secondary IDE channels by
selecting [Both]. Set to [Disabled] will disable the both. Configuration options:
[Disabled], [Primary], [Secondary], [Both].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction,
which can be applied to the configurations of "Primary IDE Slave", "Sec-
ondary IDE Master", and "Secondary IDE Slave" as well.
Advanced
Primary IDE Master
Device
Vendor
Size
LBA Mode
Block Mode
PIO Mode
Async DMA
Ultra DMA
S.M.A.R.T.
Type
LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S . M . A . R . T .
32Bit Data Transfer
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
BIOS SETUP UTILITY
[Both]
[Hard Disk]
[Not Detected]
[Not Detected]
[Not Detected]
BIOS SETUP UTILITY
:Hard Disk
:ST340014A
:40.0 GB
:Supported
:16Sectors
:4
:MultiWord DMA-2
:Ultra DMA-5
:Supported
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Disabled]
[Disabled]
DISABLED: disables the
integrated IDE
Controller.
PRIMARY: enables only
the Primary IDE
Controller.
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit