Storage Configuration - ASROCK 770 EXTREME3 User Manual

3.4.4 Storage Configuration

3.4.4 3.4.4 Storage Configuration Storage Configuration Storage Configuration
3.4.4 3.4.4 Storage Configuration
BIOS SETUP UTILITY
Advanced
Storage Configuration
[Enabled]
Onboard SATA Controller
SATA Operation Mode [IDE]
[Enabled]
Marvell SATA3 Controller
Marvell SATA3 Operation Mode [IDE]
IDE1 Master [Hard Disk]
IDE1 Slave [Not Detected]
SATAII_1 [Not Detected]
SATAII_2 [Not Detected]
[Not Detected]
SATAII_3
SATAII_4 [Not Detected]
ESATA1 [Not Detected]
Marvell SATA3_1 [Not Detected]
Marvell SATA3_2 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Onboard SATA Controller
Use this item to enable or disable the "Onboard SATA Controller" feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this
option is [IDE]. If you want to operate RAID function on SATA / SATAII HDDs,
please select [RAID]. Configuration options: [AHCI], [RAID] and [IDE].
Marvell SATA3 Controller
Use this item to enable or disable Marvell SATA3 controller. The default
value is [Enabled].
Marvell SATA3 Operation Mode
Use this item to select Marvell SATA3 operation mode. Configuration mode:
[IDE] and [AHCI]. The default value is [IDE].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "IDE1 Master" as the example in the following instruction, which can
be applied to the configurations of "IDE1 Slave" as well.
BIOS SETUP UTILITY
Advanced
IDE Master
Device :Hard Disk
Vendor :MAXTOR 6L080J4
Size :80.0 GB
LBA Mode :Supported
Block Mode :16Sectors
:4
PIO Mode
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-6
S.M.A.R.T. :Supported
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Disabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Configure onboard
serial ATA
controller.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
4 7 4 7 4 7 4 7 4 7