Table of Contents
Advertisement
2.1.6
Disk Error Detection
RAID will pop up an error message when the failure or absence of a disk drive is detected.
2.1.7
Duplicate Critical RAID 1 Array
If, during the system-booting, the software detects the inconsistence between the source and the mirror disks of RAID 1, the disk array will be
marked as critical status, and the software will automatically prompt user to duplicate the RAID 1 to make the mirror disk consist with the
corresponding source disk again.
You may click "Yes" to synchronize now or click "No" to synchronize later.
When the synchronization starts, a dialog will show the process. You can pause or cancel this process at any time. If you cancel the
synchronization process, the RAID is on "need-sync" condition. You should synchronize again to guarantee the data are identical between the
source and the mirror disk drives. A message will pop up when synchronization is finished.
2.1.8
Rebuild Broken RAID 1 array
If, during the system-booting, the failure or absence of any member disk of RAID is detected, the array will be marked as broken status. If broken
15
Advertisement
Table of Contents
