Table of Contents
Advertisement
3 . 3 . 2 Chipset Configuration
3 . 3 . 2
3 . 3 . 2
Chipset Configuration
Chipset Configuration
Chipset Configuration
3 . 3 . 2
3 . 3 . 2
Chipset Configuration
BIOS SETUP UTILITY
Advanced
Chipset Configuration
Memory Remap Feature
DRAM Frequency
Flexibility Option
DRAM CAS# Latency
DRAM RAS# to CAS# Delay
DRAM RAS# Precharge
DRAM RAS# Activate to Precha
Primary Graphics Adapter
OnBoard HD Audio
Front Panel
OnBoard Lan
CPU Voltage
DRAM Voltage
NB Core Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Memory Remap Feature
Use this item to enable or disable memory remap feature. Configuration
options: [Enabled] and [Disabled]. The default value is [Disabled].
DRAM Frequency
If [Auto] is selected, the motherboard will detect the memory module(s)
inserted and assigns appropriate frequency automatically. You may select
[333MHz (DDR2 667)], [400MHz (DDR2 800)] or [533MHz (DDR2 1066)] for
DDR2 memory modules, or select [400MHz (DDR3 800)], [533MHz (DDR3
1066)] or [667MHz (DDR3 1333)] for DDR3 memory modules. The configura-
tion options depend on the CPU and memory module you adopt on this
motherboard. Please refer to page 8 for the CPU FSB frequency and its corre-
sponding memory support frequency.
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
DRAM CAS# Latency
Use this item to adjust the means of memory accessing. Configuration
options for DDR2 memory modules are [3], [4], [5], [6] and [Auto].
Configuration options for DDR3 memory modules are are [5], [6], [7], [8],
[9] and [Auto].
DRAM RAS# to CAS# Delay
This controls the latency between the DRAM active command and the
read / write command. Configuration options: [Auto], [3 DRAM Clocks], [4
DRAM Clocks], [5 DRAM Clocks] and [6 DRAM Clocks].
DRAM RAS# Precharge
This controls the idle clocks after a precharge command is issued.
Configuration options: [Auto], [3 DRAM Clocks], [4 DRAM Clocks],
[5 DRAM Clocks] and [6 DRAM Clocks].
ENABLE: Allow
[Disabled]
remapping of
[Auto]
overlapped PCI memory
[Disabled]
above the total
[Auto]
physical memory.
[Auto]
[Auto]
DISABLE: Do not allow
[Auto]
remapping of memory.
[PCI]
[Auto]
Select Screen
[Auto]
Select Item
[Enabled]
+ -
Change Option
F1
General Help
[Auto]
F9
Load Defaults
[Auto]
F10
Save and Exit
[Auto]
ESC
Exit
4 8
4 8
4 8
4 8
4 8
Advertisement
Table of Contents
