About The I/O Cable - Omron ZFV Datasheet

About the I/O cable

The following shows the leads that comprise the I/O cable.
(1) Power Supply
This connects the power supply.
Use a DC power supply with safe extra-low-voltage circuits to prevent high voltage.
Wire the power supply separately from other devices. Wiring them together or placing them in the same duct may cause induction, resulting
in malfunction or damage.
(2) GND
The GND terminal is the 0 V power supply terminal.
(3) OUTPUT (control output)
This outputs judgment results. This lead is interlocked with OUTPUT LED.
(4) ENABLE (enable output)
This turns ON when the sensor is ready for measurement.
(5) ERROR (error output)
This turns ON when an error is generated. This lead is interlocked with ERR LED.
(6) TEACH (teching input)
There are two teaching modes, workpiece stop teaching and workpiece move teaching. These teaching modes can be selected in the menu.
(7) TRIG (measurement trigger input)
There are two measurement modes, synchronus measurement and continuos measurement. Which mode of measurement is to be per-
formed in is selected in the menu.
(8) BANK1 (bank swichting input 1)
(9) BANK2 (bank swichting input 2)
(10) BANK3 (bank swichting input 3)
The bank No. can be switched when the BANK1 to BANK3 are connected as follows
Bank No.
BANK1 OFF
BANK2 ON
BANK3 OFF
BANK4 ON
BANK5 OFF
BANK6 ON
BANK7 OFF
BANK8 ON
ZFV
* : Enabled only in the RUN mode
BANK1 BANK2
OFF
OFF
ON
ON
OFF
OFF
ON
ON
Brown
(1) Power supply
Blue
(2) GND
Black
(3) OUTPUT*
Orange
(4) ENABLE
Light blue
(5) ERROR
Yellow
(6) TEACH*
Pink
(7) TRIG*
Gray
(8) BANK1*
Green
(9) BANK2*
Red
(10) BANK3*
Purple
Unused
White
Unused
BANK3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
.
C-9