Table of Contents
Advertisement
TROUBLESHOOTING
Subtitles are not shown.
Flickering black-and-white picture.
Ejecting a trapped disc.
• There may be a mistake in the audio setup. Reset to the original settings.
• Press the "SUBTITLE" button on the remote control to switch the subtitles
on.
• The subtitle display is only supported on DVD-Video discs.
• Please check if the DVD player is connected to a VCR or a TV/Video-Set. If
so, there will be the Macrovision copyright protection. Please directly con-
nect your device to the TV and not to the VCR.
• The emergency eject feature allows you to remove a disc from the disc drive
in the very rare case that the tray will not open. Please consider that the
emergency eject does not work in each case, e.g. defective DVD-ROM
drive.
- Disconnect the player from the power supply.
- On the bottom of your player you can see one larger oval opening (please
see the picture on the left side).
- Push the plastic pin (marked with a circle on the picture) with help of a slim
and plane object (e.g. slotted screwdriver) to the right side (about 2 cm;
see the arrows on the picture). The tray will then open.
- Remove the disc from the tray. Close the tray again by hand.
65
Advertisement
Table of Contents
