Table of Contents
Advertisement
Description
Caution
5-1-9 Lamp and Touch Switch Display Status Enquiry
Format
Description
5-1-10 Touch Switch and Function Key Disable
Format
Description
Comment
5-1-11 Touch Switch and Function Key Enable
Format
Description
n
n
:
Lamp or touch switch address (2-digit hexadecimal)
1
2
NT20M, NT2000M, NT600M: 00 to FF
Changes the lamp or touch switch lighting status.
Specify the display status as 3 (all not lit) to turn off all the lamps and touch
switches. In this case, specify the lamp or touch switch number to any number in
the permitted range.
The display attributes set with the Support Tool determine if lamps #0 to #111
light continuously or flash. The display status set with this command is ignored.
n
n
:
Lamp or touch switch address (2-digit hexadecimal)
1
2
NT20M, NT2000M, NT600M: 00 to FF
Enquires the status of a lamp or touch switch specified by its address.
The PT returns the Lamp and Touch Switch Display Status Response Command
(refer to 5-2-8 Lamp and Touch Switch Display Status Response ) to report the
display status.
m
: Type of switch to be disabled
1
0 (30
): Touch switches and function keys
H
1 (31
): Function keys
H
2 (32
): Touch switches
H
Disables touch switch and function key input and notification to the host comput-
er.
Use the Touch Switch and Function Key Enable Command (refer to 5-1-11
Touch Switch and Function Key Enable ) to use a disabled touch switch or func-
tion key again. Disabled touch switches and function keys are also enabled
when the PT power is turned off.
m
: Type of switch to be enabled
1
0 (30
): Touch switches and function keys
H
1 (31
): Function keys
H
2 (32
): Touch switches
H
Enables input and notification to the host computer of a disabled touch switch or
function key.
H
[ESC]
R
n
n
1
2
1B
52
H
[ESC]
U
m
1
1B
55
[ESC]
V
m
1
1B
56
Section 5-1
(0 to 255)
(0 to 255)
Advertisement
Table of Contents
