Care And Maintenance; Cleaning The Transmitter; Replacing The Fuse - Sennheiser SR 3254 Instructions For Use Manual

Care and maintenance

Cleaning the transmitter

Water can damage the electronics of
CAUTION!
the transmitter!
Water entering the housing of the transmitter
can cause a short-circuit and damage the
electronics.
Only use a slightly damp cloth to clean the
transmitter.
Before cleaning, disconnect the transmitter from the mains.
If necessary, you can clean the transmitter with a slightly
damp cloth. Do not use any cleansing agents or solvents.

Replacing the fuse

Electric shock hazard!
WARNING!
In case of improper handling, you may come into
contact with electrically conducting parts and
receive an electric shock when removing the
fuse holder.
Before removing the fuse holder, pull out the
mains connector from the wall socket.
Disconnect the transmitter completely from the mains by
pulling out the mains connector from the wall socket.
Use a screwdriver to loosen the fuse holder
Remove the fuse holder with the inserted fuse.
Replace the fuse by a new fuse with the same rating.
Reinsert the fuse holder. Make sure to insert the fuse holder
the correct way round.
The set voltage is shown at the top of the fuse holder.
Reconnect the transmitter to the mains and and switch it on
again.
.
23