Airstream CLASSIC TRAILER Owner's Manual page 88

Airstream classic trailer owners manual
Table of Contents

Advertisement

ELECTRICAL
TV ANTENNA
Manufacturer: Winegard Company, 3000 Kirkwood Street, Burlington, Iowa 52601
Phone: 800-843-4741
MANUAL ANTENNA
Raising Antenna to Operating Position
Turn elevating crank in "UP" direction until some
resistance to turning is noted. Antenna is now in
operating position.
Rotating Antenna
Make sure antenna is in "UP" position. Pull down on
directional handle with both hands until it disengages
ceiling plate and rotate for best picture and sound on
television set.
Lowering Antenna to Travel Position
G
Rotate antenna until pointer on directional handle
aligns with pointer on ceiling plate. Turn elevat-
ing crank in the "Down" direction until resistance is
noted. Antenna is now locked in travel position.
WARNING
: Antenna must be in "down" position while traveling to
prevent property damage.
Lubrication
To lubricate the elevating gear apply a liberal amount of silicone spray lubricant to the
elevating gear with the lift in the down position, then run the lift up and down a few
times to distribute lubricant over gears.
Lubricating Rotating Gear Housing
In the event that rotating the antenna becomes difficult, lubricating the bearing
surface between the rotating gear housing and the base plate can restore normal
Raising Antenna
operation. Any spray type silicone lubricant may be used.
Elevate antenna and remove setscrew from rotating gear housing as shown. Spray
lubricant into hole and around edges of gear housing. Rotate gear housing until
lubricant coats bearing surfaces and antenna rotates freely.
Rotating Antenna
Motorized Anenna- See manual included with Owner's packet
Lowering Antenna
TV Booster/12 Volt Outlet
The TV booster amplifies the signal from the TV antenna. Pushing the small button
activates and deactivates the booster. A green light comes on when the booster
is activated. For viewing while hooked up to an exterior cable TV source, turn the
booster off.
NOTE: The TV Booster must be on to
receive antenna signals and off for cable
TV operation.
Please review the antenna and booster
manuals include in your owner's packet
before operating the system.
G - 13
LUBRICATE HERE
SPRAY AROUND EDGES REMOVE SET SCREW
TV Cable
Hook Up
TV Outlet
w/Booster &
12 Outlet
12 V
Outlet
Light
Booster
Switch

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents