Table of Contents
Advertisement
Instructions for the User
8. OPERATION
To keep your wine in optimum condition, it will not be possible to switch the light on until the temperature
inside the cellar drops below 25°C.
8.1 Switching on
Whenever the cellar is receiving power, even if it is not in operation, the LED
indicating that it is
powered up will illuminate. Once the LED is on, press the button
to put the cellar into operation. The
display will show the actual temperature inside the cellar when it is switched on. You can now move on to
set the temperature you require.
8.2 Setting the temperature
The default temperature at which the thermostat is set is 15°C. If you wish to change this, simply
proceed as follows:
Press button
for a few seconds until the figure shown on the display starts to flash;
use buttons
and
to set the temperature value you require;
about 5 seconds after the last key is pressed, the display stops flashing and the chosen temperature
remains set.
Depending on whether the temperature set is higher or lower than the current temperature inside the
cellar, the appliance will start to heat up or cool down and the LED
will illuminate.
The temperature variations generated by the refrigeration elements inside the wine cellar are gradual
and cause absolutely no deterioration in the quality of the wine stored inside.
8.3 Switching on the light
To switch on the line inside the cellar, simply press key
.
To keep your wine in optimum condition, it will not be possible to switch the light on until the temperature
inside the cellar drops below 25°C.
27
Advertisement
Table of Contents
