Yupiteru MVT-7100 Owner’s Guide Owner's Manual page 9

This mode allows for the scanning of every non-empty bank.
Bank
This mode allows for up to four specified banks to be scanned.
Up to four banks from memory banks 1-0 can be specified.
The three minor modes are
Normal
This mode simply scans all non-empty memory channels.
Mode
This mode scans memory channels with the specified receive mode (AM/FM/LSB/NAM/USB/WFM; NAM
for MVT-7200 only)
Program
This mode scans memory channels that have been specially tagged.
Scan Pass
Regardless of the chosen scanning mode, channels that have been marked as 'pass' will not be scanned.
On most radios, this feature is referred to as channel lockout.
To Enable Channel Pass/lockout
1. Display the specified memory channel
2. Press FUNC + PASS
3. Note the CH indicator blinks
To Disable Channel Pass/lockout
1. Display the specified memory channel
2. Press FUNC + PASS
3. Note the CH indicator does not blink
While Scanning
If the scan stops on a channel that you do not wish to have scanned in the future, this channel can be
passed by
1. Press FUNC + PASS
2. A double beep is sounded and the scan resumes
Changing Scan Direction
All scanning modes start at the lowest applicable channel and work towards the highest. To change the
direction to scan from highest to lowest once the scan has started, turn the rotary control in a counter-
clockwise direction or press the down/left arrow key. At any time, the scanning direction can be reversed by
simply using the rotary control or arrow keys.
Resuming Scanning
If the scan stops on an active channel that you do not wish to monitor, simply use the rotary control or arrow
keys to resume the scan.
Canceling Scan
To cancel a scan while it is running, simply press SCAN or MR.
The Six Scanning Modes
Continuous Normal
This mode is used to scan every programmed memory channel in every bank.