Beep; Delay; Lamp; Monitor - Yupiteru MVT-7100 Owner’s Guide Owner's Manual

Beep

The MVT-7100 sounds a beep tone each time a key is pressed. This helps to provide audible feedback
during radio operations. Shipped from the factory, the beep tone is enabled which can be verified by the
presence of the BEEP indicator. For more discreet operations, it may be necessary to disable this feature.
To disable the beep tone
1. Press FUNC2 + BEEP
2. The BEEP indicator disappears
To enable the beep tone
1. Press FUNC2 + BEEP
2. The BEEP indicator appears

Delay

During a scan or search operation, after a transmission ends, there will be a two second delay before the
scan/search is resumed. This delay allows for a response to be heard. To increase this delay time to four
seconds, the Delay function is used.
To enable Delay
1. Press FUNC + DELAY
2. The DLY indicator appears
To disable Delay
1. Press FUNC + DELAY
2. The DLY indicator disappears

Lamp

The MVT-7100 contains a brilliant backlighting system which is used to illuminate both the display and
keypad for night time operations.
On the MVT-7100, the LAMP button must be pressed and held to activate the backlight. When the buttons
is released, the backlight turns off.
The MVT-7200 comes with a switch that can be used to keep the backlight on if so desired.
NOTE : Excessive use of the Lamp feature will dramatically reduce the operational time of the radio when
batteries are being used.

Monitor

The MONI button on the side of the radio is used it immediately open the squelch to help aid in the
reception of signals whose strength might be below the squelch threshold or for monitoring weak signals
which are fading in and out resulting in repetitive squelch operations.

Reset

The MVT-7100 has a reset feature that allows the processor to be reset should the radio act peculiar. Using
this feature effectively restores the radio to the condition it was in when it left the factory.
ALL MEMORY DATA WILL BE ERASED! ALL SEARCH BANDS AND VFO SETTINGS WILL BE RESET TO
THEIR DEFAULT VALUES!
To perform the reset
1. Make sure the radio is powered on
2. Use a small object to press and hold the micro switch located beneath the small opening on the side
panel
3. The radio will reset and then go to VFO mode