Table of Contents
Advertisement
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes• To ensure safe and proper operation of your
tractor all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness• Review the video cassette before
you begin.
TOOLS REQUIRED FOR
ASSEMBLY
A socketwrenchset will make assembly
easier. Standardwrenchsizes you need
are listed below.
(1) 9/16"wrench
(1) Pliers
(2) 1/2" wrench
(1) Utilityknife
(1) Tire pressuregauge
When rightor left hand is mentionedin
this manual, it means, from yourpointof
view,when you are in the operating
position(seated behindthe steering
wheel).
TO REMOVETRACTOR FROM
CARTON
• Remove all accessiblelooseparts
and partscartonsfrom carton.
• Cul, from top to bottom, along lineson
all four cornersof carton, and lay
panels flat.
• Check for any additionalloose parts
or cartonsand remove.
BEFORE REMOVINGTRACTOR
FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
• Slide extension shaft onto lower
steering shaft. Align mounting holes in
extension and lower shafts and install
5/16 hex bolt and Iocknut. Tighten
securely.
• Place tabs of steering boot over tab
slots in dash and push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so
they are pointing straight forward,
• Remove steering wheel adapter from
steering wheel and slide adapter onto
steering shaft extension•
• Position steering wheel so cross bars
are horizontal (left to right) and slide
inside boot and onto adapter•
• Assemble large flat washer, 3/8 lock
washer, 3/8 hex bolt and tighten
securely.
• Snap steering wheel insert into center
of steering wheel.
• Remove protective materials from
tractor hood and grill•
IMPORTANT:
Check for and remove any
staples in skid that may puncture tires
where tractor is to roll off skid.
SteeringWheel insert
o,t
";._
'--TJ-_Large Flat Washer
Steering Wheel _-_---
abs
Stae,ng Boot" L/'F
Adapter_
_//Extension
Shaft
5/16 Lockr'_t_
L
IJ_ --._
5/16 Rex Bolt
Lower Steering
._-
,_,
Shaft _
,
,._
__
,
_ " -_
,
,
Slots
HOWTO
SET UPYOURTRACTOR
CHECK BATTERY
• Lift seat pan to raised position and
open battery box door.
• if this ba_.teryis put into sewice after
month and year indicated on label
(label located between terminals)
charge battery for minimum of one hour
at 6-10 amps. (See "BATTERY
in
Maintenance section of this manual for
charging instructions).
Advertisement
Table of Contents
