Washing Programs - Smeg LSE5304XA Instruction Manual

User instructions
To re-enable the acoustic device repeat the following procedure:
press down the HALF LOAD (6) button for a few seconds until the bN symbol appears on the
•
INFORMATION DISPLAY (7);
press the HALF LOAD (6) button again to enable to acoustic device (the symbol bS appears);
•
press the START/STOP (5) button twice to exit the set-up mode.
•
3.3

Washing programs

The dishwasher is equipped with a control panel and an INFORMATION DISPLAY, described in
chapter "3. Description of the controls", from which it is possible to carry out all the power switch-
on, switch-off and programming operations.
Before starting a washing program make sure that:
The water supply tap is open.
•
The correct amount of detergent has been added to the dispenser .
•
The baskets have been correctly loaded.
•
The spray arms are able to rotate freely and without obstruction.
•
The dishwasher door is securely closed .
•
HALF LOAD WASH SETTING
This function is especially suitable for loads up to 6 place settings and allows saving of water and
electricity. It is controlled by the HALF LOAD button (6) and allows washing in the upper basket
only.
IMPORTANT: at the end of the program remember to deactivate the function to ensure the next
wash is not also carried out in half load mode by mistake.
A cutlery basket can be placed in the upper basket , while the lower basket must be left empty.
CAUTION: there is no point in loading dishes and cutlery in the lower basket, since the jet of
water will only reach the upper basket.
CANCELLING THE CURRENT PROGRAM
To cancel the currently selected program, press the START/STOP (5) button for a few seconds,
until the active program appears on the INFORMATION DISPLAY (7). At this point, to halt the
program in progress simultaneously press the HALF LOAD (6) button and the START/STOP (5)
button. The INFORMATION DISPLAY (7) will show the letter P followed by a dash (P-) and the
dishwasher will automatically advance to the end of cycle.
CHANGING THE PROGRAM
To change the program, press and hold down the START/STOP (5) button for a few seconds, then
select the new program as described previously in the instructions; press the START/STOP (5)
button again, holding it down for a few seconds.
35