Installing The Unit - Kenwood KNA-L50 Instruction Manual

Connection/Installation
Ñ
Supplied accessories for
installation
1
(3 m)
2
3
4
5
6
Ñ
Installation procedure
1) To prevent a short circuit, remove the key
from the ignition and disconnect the ¤
terminal of the battery.
2) Make the proper input and output wire
connections for each unit.
3) Connect the wire on the wiring harness.
4) Connect the wiring harness connector to the
unit.
5) Install the unit in your car.
6) Reconnect the ¤ terminal of the battery.
7) Perform the Initial Setup.
See Initial setup (P.8).
48
(3.5 m)
(M4 x 6 mm)
(Ø4 x 16 mm)

Installing the unit

Ñ
Securing to audio board
1) Mount the brackets (accessory 6) to this unit
using screws (accessory 4).
x1
2) Secure this unit to the vehicle (audio board,
etc.) using screws (accessory 5).
x1
x1
4
Board etc.
x4
thickness: 20 mm or more
NOTE
• When installing to the car, the unit should be
x4
securely fastened at a location that will not
interfere with driving.
• When making a hole in the chassis, check that the
gas tank, break pipe, wire harness, or other part is
not located on the other side, and be careful not
x1
to cause scratches.
5
6
Carpet