Making A Power Measurement - HP 8153A Operating And Programming Manual

1
O I
M.M.
Figure 1-5. The Display at the Start of the Sample Session
3. Press
(Mode).
The instrument goes to menu mode. It shows the MEMU mode
indicator at the top of the display and the word MENU in the character field
at the bottom of the display.
4. Press (
System
1. The instrument goes into system mode, it shows the MENU SYS
mode indicator. The character field shows the message RECALL. The rest of
the display is oil'.
5. Press
(Edit).
The instrument shows the MENU SYS EDIT mode indicator and
the message RECALL 0-+ A shows in the character field.
6. Press
(Exec)
to recall the standard setting for channel A. The RUN operation
indicator shows while the setting is being recalld.
7. Press (J). The instrument shows the message RECALL 0^ B in the
character field.
8.
Press
(Exec)
to recall the standard setting for channel
B.
9. Press (Mode) to return the instrument to measure mode.
Making A Power Measurement
Note
Normally, the instrument is left for 20 minutes to warm up.
Maximum accuracy is only possible if the instrument is allowed
to warm up, For this sample session we do not need this
accuracy, so you can go to the next step immediately.
Getting Started 1-9