Table of Contents
Advertisement
12.3 Cleaning the refrigerator
Before cleaning, disconnect the plug from the electrical mains. Clean the outside using only water and a
gentle liquid detergent or an ordinary detergent for washable surfaces (such as a window-cleaning
product). Never use products containing abrasives or substances which may attack the lacquered or
painted parts, acids or chemical solvents. Use a sponge or a soft cloth.
Do not use steam cleaners to clean the inside; the procedures and products recommended for the
outside should be used.
Remove the shelves as described in "8.3 Movable removable shelves". Once the shelves have been
removed, the glass shelf can also be removed for more thorough cleaning.
the electrical lighting components with water or detergents.
Clean the gaskets with warm water and then dry.
To allow the refrigerator to operate at full efficiency, periodically also clean the condenser on the rear
with a cloth, to prevent excessive dust and dirt from collecting and interfering with its operation.
12.4 Switching off the refrigerator
If the refrigerator is not to be used for a lengthy period, keep the two
pressed for about 3 or 4 seconds. Then empty the compartments, disconnect the appliance from the
electrical mains, and once it has defrosted dry any residual moisture which has collected. Leave the door
ajar to prevent the humidity and trapped air from creating unpleasant smells.
The appliance should not be left unattended for more than 3-4 days. If you are to be away for some time,
it is best to switch off both the refrigerator and the freezer sections.
12.5 Practical advice for saving energy
-
Install the refrigerator in a cool, well ventilated place, protected against direct sunlight and well away
from heat sources;
-
do not place hot foods in the refrigerator or freezer sections. Wait for foods and drinks to cool to room
temperature before placing them on the shelves;
-
open the door(s) as infrequently and for as short a time as possible to prevent the compartments from
warming up too much;
-
clean the condenser (rear of the refrigerator) periodically to prevent the appliance from losing
efficiency;
-
do not leave the turbo-cooling and rapid freezing function activated for longer than absolutely
necessary;
-
if the refrigerator is to be out of use for a long period, it is best to empty it and switch it off;
-
thaw frozen foods in the refrigerator section in order to exploit the cold stored in the frozen foods,
which will be transferred to the refrigerator if this procedure is used.
Instructions for the User
It is also possible to leave the other shelves in place and remove the
glass shelf only.
This operation can be carried out following the instructions provided
below.
Insert your hand between the glass and the steel frame, close to the
retainer, and then press on the glass with your thumb. Once the glass
has been freed from the first retainer, repeat the operation for the second
one. To put the glass back in place, simply press it until it fits flush against
the steel frame.
To remove the door shelves and bottle shelf simply lift them out, taking
care not to apply excessive force when removing.
Never wash removable plastic parts in the dishwasher; use only warm
water and washing-up liquid or water and vinegar. Take care not to wet
buttons on the control panel
43
Advertisement
Table of Contents
