Changing A Wiper Blade - CITROEN C3 AIRCROSS Handbook

Do not operate the wipers on a dry
windscreen. Under extremely hot or
cold conditions, ensure that the wiper blades
are not stuck to the windscreen before
operating the wipers.
Windscreen wipers
► To select the wiping speed: raise or lower
the stalk to the desired position.
Single wiping / Mist
Off
Intermittent wiping
Slow wiping
Fast wiping
Single wipe
► Pull the stalk briefly towards you.
Front screenwash
► Pull the wiper control stalk towards you and
hold.
The screenwash and windscreen wipers operate
for as long as the control stalk is pulled.
Termination of the screenwash is followed by a
final wiping cycle.
To avoid damaging the wiper blades,
do not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the fluid freezing on the windscreen
and hindering visibility. During the winter
period, use "very cold climate" rated
products.
Never top up with water.
Rear wiper
(Depending on version)
► Turn the ring to align the desired symbol
with the marking.
Screenwash-wipe
Off
Lighting and visibility
Intermittent wiping

Changing a wiper blade

Before removing a front wiper
► Within one minute after switching off the
ignition, operate the wiper stalk to position the
wiper blades vertically on the windscreen.
or
► A minute after switching off the ignition,
straighten the arms manually.
Removing
► Lift the corresponding wiper arm.
► Unclip the wiper blade and remove it.
Refitting
► Position and clip the new wiper blade to the
arm.
► Fold down the wiper arm carefully.
After refitting a front wiper
► Switch on the ignition.
4
27