Advertisement
2. Troubleshooting
The dishwasher is equipped with a self-diagnostics system that is
capable of detecting and signalling a number of possible faults.
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT
Acquastop failure
The anti-flooding system has been activated (for the relevant models
E1
only). The system is tripped in case of water leaks. Contact the after-
sales service.
Safety level
The system which limits the water level inside the dishwasher has been
E2
tripped. Interrupt the program and switch off the dishwasher. Switch the
dishwasher back on, program it again and start the washing cycle. If the
problem persists, contact the after-sales service.
Water heating malfunction
The water is not heated or the heating parameters are not correct.
E3
Repeat the washing program; if the problem persists, contact the after-
sales service.
Water temperature monitoring malfunction
Interrupt the program and switch off the dishwasher. Switch the
E4
dishwasher back on, program it again and start the washing cycle. If the
problem persists, contact the after-sales service.
Water intake malfunction
The appliance does not take in water or does not do so correctly. Check
E5
that the water connections are correct, the water intake tap is turned on
and the filter is not fouled. If the problem persists, contact the after-
sales service.
Water pump-out malfunction
The appliance does not pump out the water or does not do so correctly.
E6
Check that the drain hose is not kinked or crushed and that the siphon
and filter are not fouled. If the problem persists, contact the after-sales
service.
User instructions
DESCRIPTION
Advertisement
