Using The Timer; Other Settings; Configuring Flash Alert Settings; Other Information - Casio 3529 Operation Manual

Using the Timer

1.
Enter the Timer Mode.
Navigating Between Modes
l
Hour, minute, second
2.
Use the operations below to perform a
timer operation.
D
Start
(Countdown starts)
D
Pause
D
Resume
(Time up)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
When using the auto-repeat timer with
●
a countdown of 10 seconds or less, the
countdown end beeper will sound for
only one second.
To reset a paused countdown to the
●
start time, press (A).
3.
Press any button to stop the tone.
Note
If flash alert is enabled, display
●
illumination flashes along with the
beeper at the end of the countdown.
Pressing any button to stop the alarm
beeper also stops the flash alert
operation.

Configuring Flash Alert Settings

l
Watch Operation Guide 3529

Other Settings

This section explains other watch settings you
can configure.
Configuring Flash Alert
Settings
If flash alert is enabled, display illumination will
automatically flash along with the alarm, timer,
and other beepers.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds to
toggle flash alert between enabled and
disabled.
Flash alert toggles between on and off
●
each time you hold down (D).
●
enabled.
is displayed while flash alert is

Other Information

This section provides non-operational
information you also need to know. Refer to
this information as required.

Specifications

Accuracy at normal temperature :
±15 seconds a month
Timekeeping :
Hour, minute, second, year, month, day,
day of the week
a.m./p.m. (P)/24-hour (24) timekeeping
Full Auto Calendar (2000 to 2099) *
* Year display on setting screen only.
Alarm :
Time alarm
Setting units: month, day, hour, minute
Alarm beeper duration: 20 seconds
Hourly time signal: Beep every hour on the
hour
Timer :
Measuring unit: 1 second
Countdown range: 24 hours
Time setting unit: 1 second
Auto Repeat
10-second beeper when the end of the
countdown is reached
Stopwatch :
Measurement units:
1/100 seconds (first hour); 1 second
(after first hour)
Measuring range:
23 hours, 59 minutes, 59 seconds (24
hours)
Measurement Functions:
Elapsed time, cumulative time, split
times, 1st and 2nd place finisher times
Other :
Auto return, 12-/24-hour timekeeping, LED
backlight (Super Illuminator, afterglow),
flash alert
Power Supply :
CR2016 x 1
Battery nominal voltage: 3V
Battery life: Approximately 5 years
Conditions:
Alarm: Once (20 seconds)/day (flash
alert enabled)
Illumination: Once (3.5 seconds)/day
Specifications are subject to change without
notice.
11