Table of Contents
Advertisement
Section 4 - Configuration
The Static Routes page allows you to define custom routes to control how data
traffic is moved around your network. To access this page, go to Features >
Static Route.
If you wish to remove a rule, click
in the Edit column. If you wish to create a new rule, click the Add
rule, click
Rule button. Click Save when you are done.
Complete the following to create or edit a rule:
Create New Rule
Destination
Enter the destination subnetwork IP address.
Address:
Destination
Enter the subnet mask of the destination address. The subnet mask
Subnet Mask
determines an IPv4 subnetwork.
Gateway IP
Enter your next hop gateway to be taken if this route is used.
Address:
Service Number:
Specify the interface to transit the packets of this static route.
Metric:
The route metric is a value from 0 to 15 that indicates the cost of
using this route.
Click Apply when you are done. A maximum of 16 rules can be defined.
D-Link DSL-X3052E User Manual
Static Route
in the Delete column. If you wish to edit a
73
Advertisement
Table of Contents
