Connection Types; Connection Type: Dynamic Ip (Dhcp) - D-Link DSL-X3052E User Manual

Section 4 - Configuration
Select Dynamic IP Address (DHCP) to obtain an IP address automatically
from your ISP. Select this option if your ISP does not provide you with a specific
IP address.
IPv4 Settings
Select Dynamic IP Address (DHCP).
Connection:
Service List: Select a service type from the list. Choose from INTERNET,
TR069_INTERNET, VOICE, VOICE_INTERNET, TR069_VOICE,
TR069_VOICE_INTERNET, TR069, or OTHER. This information should
be provided by your ISP. If you are configuring your connection
manually and your ISP has not specified this setting, INTERNET is
recommended.
Select IPv4, IPv6 or IPv4/IPv6 for both IPv4 and IPv6 addressing
Protocol:
mechanism. If you choose IPv6, refer to the below IPv6 Settings.
Advanced Settings
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP. The default is 1492.
NAT Enable:
Network address translation (NAT) translates private IP addresses to
public IP addresses prior to allowing private IP networks to connect
to the public network. This option is not available for voice or TR069
service types such as VOICE, TR069_VOICE, and TR069 for Ethernet
WAN.
Select Bridged IP LLC or Bridged IP VC-Mux as the encapsulation
Connection Type:
method. This is only available for ADSL.
D-Link DSL-X3052E User Manual

Connection Types

Connection Type: Dynamic IP (DHCP)

35