2. Carefully peel the copper foil that secures the antenna cables on both sides of the display-assembly base.
3. Lift the antenna modules off the display-assembly base.
Installing the antennas
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the antennas and provides a visual representation of the installation procedure.
Figure 59. Installing the antennas
Steps
1. Align and place the antenna modules into the slots on the display-assembly base.
NOTE:
The location of the antenna modules is printed on the display-assembly base as ANT-B (black) and ANT-W
(white).
2. Adhere the copper foil that secures the antenna cables on both sides of the display-assembly base.
3. Route the antenna cables through the routing guides on the display-assembly base.
Next steps
1. Install the
power-button board with
2. Install the
stand
hinges.
3. Install the speakers.
4. Install the
system
board.
5. Install the
integrated heat sink
6. Install the
M.2 2230 solid-state
7. Install the
wireless
card.
8. Install the
memory
module.
86
Removing and installing Field Replaceable Units (FRUs)
USB.
or,
discrete heat
sink, as applicable.
drive.