Steps
1. Place the I/O cover on the display-assembly base.
2. Align the screw holes on the I/O cover with the screw holes on the display-assembly base.
3. Replace the two screws (M3x5) that secure the I/O cover to the display-assembly base and snap the I/O cover back into
place.
Next steps
1. Install the
back
cover.
2. Install the stand.
3. Follow the procedure in
Stand hinges
Removing the stand hinges
Prerequisites
1. Follow the procedure in
2. Remove the stand.
3. Remove the
back
cover.
4. Remove the
I/O
cover.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. See the procedure for
About this task
The following image indicates the location of the stand hinges and provides a visual representation of the removal procedure.
Figure 24. Removing the stand hinges
Steps
1. Remove the 10 screws (M3x4.5) that secure the right and left stand hinges to the display-assembly base.
48
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
removing the stand
and
installing the
stand.