3.3 Selecting lamp operation mode
Select the DUAL or ALTERNATE lamp operation mode.
1.
Highlight LAMP MODE in the STACK menu with
the ▲/▼ buttons, then press the ► button to
display the LAMP MODE dialog.
2.
Use the ▲/▼ buttons in the dialog to highlight DUAL or ALTERNATE.
DUAL: Turns on the projectors at the same time.
ALTERNATE: Turns on the projectors alternately.
3.
Press the ◄ button to return to the previous menu, or press the ► button to
complete the setting. ( 19 )
NOTE
• If DUAL is selected, a menu to select MAIN or SUB appears on
screen when a button on the control panel of the projector or remote control is
pressed. Select the projector that you want to operate. Refer to the examples
below.
- When the MENU button is pressed, a menu to select MAIN or SUB is
displayed. If MAIN is selected, EASY MENU or ADVANCED MENU of the
Main projector is displayed.
- When one of the buttons from KEYSTONE, FOCUS + / -, ZOOM, ZOOM + / -
and LENS SHIFT is pressed, a menu to select MAIN or SUB is displayed. If
MAIN is selected, each menu or dialog of the Main projector is displayed.
- <Only for
When the ENTER button is pressed for three seconds, a menu to select
MAIN or SUB is displayed. If MAIN is selected, the Status Monitor on the
Main Projector can be operated.
• When DUAL is selected for
LAMP MODE, there are operating
restrictions as follows.
- AUTO POWER OFF and
FREEZE functions on both
projectors are disabled.
- The test patterns for CUSTOM of
GAMMA and COLOR TEMP are
not displayed.
- It takes slightly longer time to turn
on the projectors. This is not a
malfunction.
(continued on next page)
,
and
>
Menu to select
MAIN or SUB
Menu to select
MAIN or SUB
15
STACK menu settings
Menu on Main projector
Menu on Main projector